Compact Circular Saw EN
17
TROUBLE SHOOTING
Symptom Possible Causes Possible Solution
Tool will not start when operating the
on/off switch.
Power cord not plugged in.
Power cord is broken.
Carbon brush has worn down
Check to make sure power cord is
connected well into a working outlet.
Unplug the power cord. Replace it using
a qualified maintenance person.
Replace the carbon brush using a
qualified maintenance person.
Cutting depth is less than that is set.
Sawdust accumulated at the rear
of the base.
Shake out sawdust. Consider connecting
a vacuum for dust collection.
Blade spins or slips
Blade is not tightly engaged with
the spindle.
Remove the blade, and reassemble it as
described in INSTALL/CHANGE THE
BLADE section.
Blade will not cut a straight line.
Blade is dull.
Blade is not mounted properly.
Saw is not being guided properly.
Mount a new, sharp blade on the saw.
Check that blade is properly mounted.
Use a parallel guide.
Blade kicks back when beginning
a cut
Blade is not spinning fast enough
Allow the saw blade to reach full speed
prior to beginning a cut in the material.
ENVIRONMENTAL PROTECTION
Waste electrical products must not be disposed of with household waste. Please recycle where facilities
exist. Check with your local authorities or retailer for recycling advice.
To Next Page
Loading...
