To Next Page

To Previous Page

Big hex wrench

washer

Round head screw

Use the big hex wrench to unscrew the three round head screws

and three washers on the bottom of the printer counterclockwise.

＊

Notice:

Please take good care of the removed parts.

Replace the LCD screen

Use the small hex

wrench to turn

counterclockwise to

unscrew the four flat

head screws on the

working panel and the

two flat head screws

above the knob.

＊

Notice:

❶

Please take good care of the

removed parts.

❷

Please take care of the four M3

nuts installed in the bottom of the

printer.

Small hex wrench

Flat head screw

M3 nut

Replace the LCD screen

Questions and Answers:

Need help?

Do you have a question about the Wow SparkMaker and is the answer not in the manual?

Wow SparkMaker Specifications

General