Wow SparkMaker User Manual

Replace the FEP film
49
Lay the FEP film under the tank and poke 12 holes in the
position shown with a small hex wrench.
＊
Notice:
❶
Make sure that the position of each hole that is poked matches the position of
the hole in the lower layer of the tank.
❷
Do not damage the FEP film.
❸
Clean all tank parts before replacing the new FEP film.
Lower layer of the tank
Small hex wrench
FEP lm
Replace the FEP film

Wow SparkMaker Specifications

General

Brand	Wow
Model	SparkMaker
Category	3D Printers
Language	English