EasyManuals Logo

Wow SparkMaker User Manual

Wow SparkMaker
59 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
46
After pouring the resin in the
tank
,
carefully wipe the resin
remaining in the tank and the
outer wall of the tank with a
paper towel.
Paper towel
Tank
Use a plastic shovel to remove
the residual resin stuck on the
FEP film at the bottom of the
tank.
Notice:
Please be careful to prevent the bottom of
the tank from being scratched.
Residual resin
Shovel
Tank
Recycled resin and tank cleaning
47
Finally
,
carefully wipe the inside of the tank
,
the outer wall of the
tank and the upper and lower sides of the FEP membrane with
alcohol wipes
.
Notice:
The standard of thorough cleaning is that the FEP film is completely free of residue and no
resin,and there is no resin residue inside and outside the tank.
Alcohol wipe
Tank
FEP membrane
Recycled resin and tank cleaning

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Wow SparkMaker and is the answer not in the manual?

Wow SparkMaker Specifications

General IconGeneral
BrandWow
ModelSparkMaker
Category3D Printers
LanguageEnglish