42
Place the air-dried model
on a UV light or sunlight for
about 10 minutes.
＊
Notice:
❶
In order to prevent the model
from being deformed by heat during
illumination
,
the air-dried model can be
completely placed in water or glycerol.
❷
The illumination time can be
adjusted according to the intensity
of the light
,
so that the model can be
completely cured.
❸
Excessive curing time will cause the
model to shrink and yellow
,
Insufficient
curing time will result in incomplete
curing of the model
,
and it will cause the
model to be too soft.
Model
UV light
End of printing
Adjustment of the printer
Recycled resin and tank cleaning
To Next Page
Loading...