40
Model
Model
Scissors
Support
Carefully cut off the support on the model with tools such as scissors or
cutting pliers.
＊
Notice:
❶
Please use tools such as scissors carefully to avoid accidental injury and damage to the model.
❷
The support can be softened by the use of an electric blowing hot wind to soften the support
,
making
it easier to dismantle.
End of printing
41
Place the trimmed model in
a cleaning container
,
pour
the appropriate amount of
alcohol that concentration
above 95%
,
clean it with
a soft brush or ultrasonic
vibration for about 60
seconds
,
clean the uncured
resin on the model surface
,
then take out the model
,
and
blow dry the model with
cold air.
＊
Notice:
❶
You can use a hair dryer to speed up
the evaporation of the model surface
alcohol.
❷
Do not wash for too long
,
avoid
model damage and peeling.
❸
Please carefully use and store
alcohol to avoid safety issues.
Model
Cleaning container
Alcohol
End of printing
To Next Page
Loading...
Need help?
General