38
Tilt the platform so that
the resin remaining on
the aluminum plate and
the model flows back into
the tank along a corner
of the aluminum plate.
＊
Notice:
When tilting the platform
,
do not
drop the resin on the outer wall
of the tank
,
the mounting screw
holes
,
the working panel
,
the outer
casing and the cover
,
and the
installation clearance.
Aluminum plate
Model
Resin
Tank
End of printing
39
Use a knife or shovel to separate the model from the aluminum plate along
the bottom of the model.
＊
Notice:
❶
Please use tools and
shovel carefully to avoid
accidental injury.
❷
Please lift up or cut from
the bottom of the model.
Do not leave too deep
scratches on the bottom
of the platform and avoid
damage to the model.
❸
Please clean the
resin residue stick to the
platform.
Model
Aluminum plate
Knife
End of printing
To Next Page
Loading...
Need help?
General