To Next Page

To Previous Page

Replace the LCD screen

Use the big hex wrench

to unscrew the screw on

both sides of the tank

counterclockwise and

remove the tank upward.

＊

Notice:

❶

Please remove the printing

platform first.

❷

When removing the tank

do not

drop the resin on the outer wall

of the tank

the mounting screw

holes

the working panel

the outer

casing and the cover

and the

installation interspace.

❸

Do not scratch the FEP film

at the bottom of the tank when

removing the tank.

❹

Please place the removed

tank properly on a clean and soft

surface to avoid damage.

Big hex wrench

Round head screw

Tank

Replace the LCD screen

Questions and Answers:

Need help?

Do you have a question about the Wow SparkMaker and is the answer not in the manual?

Wow SparkMaker Specifications

General