WowWee 1045 - Program Mode

Program Mode
16
Program Mode
YoucanprogramWrextheDawgtoperformasequenceofactionsupto80steps.
Thesequencecanincludemovements,tricksandresetcodesthatwillmakehim
performanimations(butnotchangehismode)aspartofthesequence.
ToprogramWrextheDawg,dothefollowing:
1.PointtheremotecontrolleratWrextheDawgandpresstheProgrambutton.
2.Entercommandsusingtheremotecontroller.Hewillperformafewsecondsof
thecommandandthenstoreitasaprogramstep.
3.Ifyoudonotenteraprogramstepforapproximately30seconds,hewillstorethe
programandplayitback.HewillthenexitProgram Mode.
Alternatively,tostoretheprogram,pressthePlaybackbutton.WrextheDawg
willplaybacktheprogramandthenexitProgram Mode.
NOTE: Ifyouenternewprogramstepswhenaprogramisalreadystored,thenew
programstepswillbeaddedtothepreviouslystoredprogram,upto80steps.
WrextheDawgwillstoretheprogram,includingwhenheisinSleep Mode,until
heisturnedoff,unlessyouenteranewprogram.
TohaveWrextheDawgplaybackthestoredprogram:
 •PointtheremotecontrollerathimandpressthePlaybackbutton.
NOTE: WrextheDawgdoesnotuseEdgeDetectionorobstacleavoidanceduring
playback;ensurehissurroundingareaisfreefromobstaclesandedges.
NOTE: HewillnotplaybacktheroutinewhenheisinGuard Mode.
Todeletetheprogram:

 •EnterProgram ModeandthenpresstheProgrambuttontwicequickly.