WYBOT C1 Pro - Filter Cleaning and Maintenance; Performing Filter Cleaning

DO A FILTER CLEANING
07 08
Let it sink down to the floor.
Note:
To achieve an optimal cleaning performance, you should ensure the water depth
of the pool is at least 19.5 in (50 cm) high from the top of the device.
Take out the filter basket. Empty all debris and rinse it with clean
water.
Hold the filter cover handle, press and open it.
The cleaner begins to clean walls, floor
and waterline as default or your set.
About 20 seconds of auto calibration
on the floor, the indicator light will turn
flashing blue. The cleaner is ready to
clean.
The device will automatically move to
stop by the edge of wall when finishing
cleaning or battery low.
You can insert the included hook into
a pool rod and lift the cleaner out of
the pool.
You should take the cleaner out verti-
cally to drain inside water out quickly.
Note:
1. You should ensure the device is powered off when open the top cover.
2. You need to clean the filter basket before being dry.
Note:
If you have preset a cleaning cycle other than the default one, you should leave the
cleaner in the pool to complete the whole cycle.
1
2
3
4
5
3
4
1
2