05 06
Choose your cleaning mode
iOS Android
iOS 15.0 or later Android 8.0 or later
Note:
1. You can preset your cleaning mode before putting the device into the pool.
The default mode is full pool cleaning.
2. If the device restarts, it will automatically enter the cleaning mode you set last
time
Hold the handle of the cleaner and submerge it into the pool within 3 minutes, other-
wise the device will be turned off. Additionally, you should not release it until no bubble
comes out.
Run your new WYBOT C1 Pro/Max(OS7010/OS7010 Max)
Cleaning Range
Mode
Wall+ Floor+Waterline/Wall then floor
Floor only/Turbo floor/ECO floor
Full pool cleaning
Floor cleaning
Wall cleaning
Wall only
Preset your cleaning cycle via the app
You can start to schedule your cleaning cycle through clicking the “cycle timer” on
the app, and select the one you prefer. You may refer to below for a better under-
standing of the working principle.
Note:
1. If you have selected a cycle cleaning mode, you should ensure the cleaner is fully
charged before.
2. The default cleaning cycle of WYBOT C1 Pro(OS7010) is one time cleaning for 2 hours,
and WYBOT C1 Max(OS7010 Max) is one time cleaning for 3 hours.
3. If your select other cleaning cycles, you should keep the cleaner in the pool to
complete whole cycles.
There are 3 cleaning modes on the device, and you can see details below.
You can preset a suitable cleaning mode for your device on the device through press-
ing the on/off button. You can also select one cleaning mode via the app.
eg WYBOT C1 Pro(OS7010/OS7010 Max) cycle timer
Cycle 1 120min*1
Cycle 2 60min*2
Cycle 3 40min*3
Cycle 4 30min*4
(default)
24 hours
60min.
60min.
1st day
2nd day
24 hours
40min.
24 hours
40min.
1st day
2nd day
40min.
3rd day
120min.
1st day
48 hours
30min.
48 hours
30min.
1st day
3rd day
30min.
5th day
48 hours
30min.
7th day
*You can define a specific mode from the app
*You can define a specific mode from the app
To Next Page
Loading...
