What to do if X3i X7A Desktop shows 'No OS Found'?
If your X3i Desktop displays a “No OS Found” message, power cycle the computer by holding the power button for about 5 seconds until it shuts off. Then, unplug the power cord for a few seconds before plugging it back in. Also, make sure there are no USB storage devices plugged in, as the computer might be trying to boot from one of them.
Why is the fan on my X3i Desktop so loud?
If the fan in your X3i Desktop is making loud noises, it could be due to a bad fan bearing or the fan becoming slightly turned or leaning. If a fan bearing is going bad, the fan needs to be replaced. Most customers can fix this problem themselves with a replacement fan, Torx wrench, needle nose pliers and some basic instructions. If one goes bad, it is recommended that you replace both at the same time as a preventative measure. Try picking up the computer and rotating the computer in the air while it is on. This can help a fan settle back into its original position.
What to do if X3i X7A Desktop doesn't wake up from sleep?
If your X3i Desktop computer goes to sleep and does not wake up, one possible solution is to refresh the BIOS. Xi3 Technical Support can provide customers with the files they need to reload the BIOS. Another workaround is to set the sleep mode in Windows to “Never.”
What is the ROOT password for X3i Desktop on Linux?
The default password for ROOT access on openSUSE Linux for X3i Desktop is: xi3password.
Warns about static discharge and how to prevent damage to the computer.
Provides a step-by-step guide for upgrading or replacing internal components.
Instructs users on how to enter the BIOS setup utility.
Guides users on modifying the boot order to start from different devices.
Lists common problems and provides initial troubleshooting steps for resolution.
Provides information on warranty, contact methods, and authorized service providers.
Outlines critical warnings regarding component handling, airflow, and liquids.
To Next Page
General