EasyManua.ls Logo

X4-TECH A-1200 - Inserting Batteries into the Remote Controls;Battery Information

X4-TECH A-1200
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
16
17
Chapter 3 The device Chapter 3 The device
18. ST/MO
Switches between a two-channel stereo and one-channel mono operation mode
19. /
Play/Pause
Starts/Pauses playback
20. Navigation buttons 
Move to the right, selects the next menu in a menu mode
Move to the left, selects the previous menu in a menu mode
Scans 0.05 MHz upwards during FM operation/moves upwards in a menu
Scans 0.05 MHz downwards during FM operation/moves downwards in a menu
21. Mode
Changes the playback mode
22. Numeric buttons
Direct access/stores memory presets 1 thru 5
23. P
Browses through preset radio stations
24. Stop
Stops playback
25. ENTER
Con rms a selection/setting
26. MENU
Press to enter a menu
27. INFO
Displays various information
28. SHIFT
Select/Store preset stations exceeding the numbers 6 thru 10 (6 = 5, then 1)
This remote control requires two „AAA” batteries for operation.
Inserting batteries into the remote control/Battery information
Inserting/changing batteries
› Carefully remove the battery compartment lid on the back of the remote control.
› Remove used batteries.
› Insert new batteries and ensure correct polarity, as graphically displayed inside the
compartment.
› Replace the battery lid carefully.
Information on handling batteries
Keep batteries out of childrens reach.
› Batteries are hazardous waste and do not belong in household waste.
› Ensure correct polarity when inserting batteries.
› Always remove batteries when the remote control is not in use for longer periods of time.
› Never leave batteries lying around unsupervised. These could pose a choking hazard to child-
ren and pets if swallowed. Seek emergency medical care immediately, should this happen.
› Never expose batteries to extreme temperatures, such as sunlight,  re, ovens, etc. there is the
risk of explosion!
› Make sure that batteries are not short-circuited and never recharge non-rechargeable batte-
ries. There is a risk of explosion!
› Always follow manufacturer instructions, when recharging rechargeable batteries.
› Touching leaking or damaged batteries could cause skin burns. Use protective gloves suitable
for handling such batteries.
› Always ensure that the device has been turned o after use.
› Always change/replace all batteries at the same time. Never mix old and new batteries or bat-
teries of di erent types.
› Clean battery and device contacts before inserting, where required.

Related product manuals