Xantrex Powerpack 100 - Using the Inverter with Powerpack

18
Using the Inverter with Powerpack
The Powerpack is designed to connect to the inverter
module and provide power to operate or charge
devices that consume 100 W or less.
To use the Powerpack:
1. Connect the inverter module to the Powerpack,
ensuring that the mounting tab on the Powerpack
slides into the slot underneath the inverter. Insert
the DC output plug on the Powerpack into the
inverter’s DC input port. See Figure 5.
When the inverter module is connected to the
Powerpack, rest the two components on a flat
surface.
2. Press the
ON/OFF switch to turn the Powerpack
on.
The LEDs on the Powerpack and the inverter
module illuminate blue.
3. Plug the device you want to operate into the
inverter. See “Inverter Operation” on page 20.
4. When not in use, press the
ON/OFF switch to turn
the Powerpack off.