Operation
3-26 975-0162-01-01
To inflate your vehicle, motorcycle, or bicycle tires:
Figure 3-15
Inflating tires
1. Locate Value Connector. Remove
from storage and uncoil hose. Install
a nozzle adapter if necessary.
2. Remove Valve Stem Cap
from tire to be inflated.
3. Place Valve Connector firmly and completely over valve stem on the tire.
4. Press the Thumb Latch toward the hose until it locks into place.
5. Press the O
N/OFF Switch to turn the compressor ON.
6. Inflate to desired pressure.
7. Press the ON/OFF Switch to turn the compressor OFF.
8. Press the Thumb Latch away from the
hose and remove from valve stem.
10.Replace Valve Stem Cap
9. Double-check the air
pressure with a pressure
gauge.
975-0162-01-01_Rev-C.book Page 26 Friday, October 20, 2006 10:40 AM
To Next Page
Loading...
