Need help?Do you have a question about the Xantrex XW4024-120/240-60 and is the answer not in the manual?
General| Model | XW4024-120/240-60 |
|---|---|
| Type | Pure Sinewave Inverter/Charger |
| Output Voltage | 120/240 VAC |
| Frequency | 60 Hz |
| Transfer Time | 16 ms typical |
| Cooling | Fan Cooled |
| Output Power | 4000 W |
| Surge Power | 8000 W |
| Protections | Overload, short circuit, over temperature |
| Input Voltage | 24 VDC nominal (21-32 VDC) |
Details on system limitations, single-phase operation, and explosive gas precautions.
Information regarding FCC rules and potential radio frequency interference.
Describes the XW Power System's components and its capability to create renewable energy systems.
Details on key components like the XW Inverter/Charger and XW Conduit Box.
Instructions for preparing the installation site and choosing an appropriate location.
Guidance on mounting the inverter and necessary clearance for ventilation.
Procedures for making AC and DC connections and routing cables.
Steps to perform basic functional tests for single and multiple inverter systems.
Instructions for installing multiple inverters, including dual and triple configurations.
Explanation of Xanbus-enabled devices and the Xanbus network system.
Details on network components, ordering, and typical network layout.
Guidelines for routing cables and installing Xanbus-enabled devices.
Covers charge controller installation, PV array requirements, and MPPT voltage range.
Instructions for choosing a location and mounting the solar charge controller.
Details on grounding, internal fault protection, and wire size requirements.
Procedures for commissioning the solar charge controller using a control panel.
Guidance on installing the XW System Control Panel.
Instructions for installing the Automatic Generator Start module.
Detailed electrical parameters for the XW Power System models.
Physical dimensions, weight, enclosure type, and temperature ratings.
Illustrates wiring configurations for single-inverter systems.
Illustrates wiring configurations for dual-inverter systems.
Provides DC grounding diagrams for single-inverter setups.
Details AC grounding configurations for single-inverter systems.
Wiring diagrams for generator and utility connections.
To Next Page