3
The next paragraphs explain the meaning of the symbols,
present on the receiver.
The caution risk of electrical shock / Do not open symbol
This symbol tell you that you are not allowed to open the receiver.
Only authorized servive technicians are allowed to open the box.
The Lightning Flash with arrowhead symbol within an equilateral
triangle, is intended to alert the user to the presence of uninsulated
“dangerous voltage” within the product enclosure that may be of
sufficient magnitude to constitute a risk of shock to persons.
The exclamation point within an equilateral triangle is intended to
alert the user to the presence of important operating and mainte-
nance (servicing) instructions in the literature accompanying the
product.
The Digital Video Broadcasting logo
This logo tells you that this receiver is compliant with the DVB stan-
dards as registered under under registration number 2347.
The double insulation symbol
This symbol tells you that the receiver is electrically safe within the
normal use of the receiver as stated in the safety chapter.
Please read these safety instructions through carefully, before
operating the receiver.
Please observe all warnings and instructions on the equipment
and contained in these operating instructions.
Be sure to read this usre’s manual before starting your operation
You must install the dish with correct direction and angle. lf the
receiver antenna is not working properly, contact your local
dealer
Never open the cover. It is very dangerous to touch the inside
of the unit due to possible electric shock.
Install the unit horizontally. Unbalanced installation may cause
the unit to be damaged by itself.
When you don’t use this unit for a long time please pull the
power cord from the outlet. Also do not use damaged power
cord.
when the unit is suddenly moved to a hot area from a cold area,
it may cause problems. In that case, turn off the power, and turn
on after 1-2 hours.
Do not touch the power with wet hand. If there is liquid flowing
into the unit, pull out the power cord immediately because it
cause fire or electric shock.
May install the unit in a place with: good ventilation, suitable
temperature, no direct sunrays, low humidity low vibration
influence.
Place the unit in a well ventilated and no heat environment.
Do not put heavy objects on the unit.
Safety Instructions
Symbols Used on the Receiver
To Next Page
Loading...
