5
Snare Installation
1.
Open Snare Stand Legs① to suitable
position and make it stand firm.
2.
Open Snare Stand Arms②, stretch it to
maximum, put the Snare upward on the stand.
The one with rubber band and white sensor spot
is the upside.
3.
Tighten Snare Stand Arms② by rotating
the rotary on the bottom side
②
①
HiHat Installation
1.
Open HiHat Stand Legs① to suitable position and
make it standfirm.
2.
Insert Thin Rod② into screw thread on the Bottom
Stand according to dashed line here, and rotate it
clockwise to fasten it.
3.
Place Hollow Rod③ outside Rod②, and insert it into
Bottom Stand.
4.
Insert HiHat Cymbal Tray④ onto Thin Rod② and place
it aboveHollow Rod③
5.
Adjust Hollow Rod③ to suitable height and fasten
it. Insert HiHat Cymbal onto Thin Rod②. Make sure there is
enough space between the Cymbal and Tray④, and then
fasten the screw on Cymbal.
Note: If there is not enough space between Cymbal
and Tray④, the HiHat control function will be very short in
range or even notresponding.
①
②
③
④
⑤
INSTALLATION
DRUM INSTALLATION - 1
To Next Page
