Xerox FreeFlow Accxes Drivers & Client Software Installation Guide 13
Enabling Selection of Finisher Options
A .FIN file is only required when bi-directional communication does not exist to FreeFlow Accxes
Client and driver software.
NOTE: The printer, controller, and PC need to be on the same network and turned on. The
FreeFlow Accxes Client Tools need to be installed. The finisher must be connected to the
printer and on so that the executable file can access the folder to create the correct .FIN
file.
Creating a .FIN file for your FreeFlow Accxes Client Tools to connect to the finisher:
1. Go to http://www.xerox.com.
2. Choose Support & Drivers.
3. Go to the Wide Format section.
4. Select the hyperlink that refers to your printer type.
5. Under your type of driver, select Drivers & Downloads.
6. Select your Operating System and Language. Press the Go button.
7. In the Utilities & Applications section, choose the “Finisher File Creator”. Save the zip file
to your PC.
8. Open the downloaded .zip file and extract the xesfin.exe file. Save it in the same place
where your ACT files are installed.
9. On your PC, start a Command Prompt window by selecting Start > Run > cmd.
10. In the Command Prompt window, change the current directory to be the same as the
location of xesfin.exe. The following screen illustrates this (see the arrows).
To Next Page
Loading...
Need help?
General
