4. To remove the jammed staples, pull the staples in the direction shown.
WARNING: The points of the jammed staples are sharp. Remove the jammed staples
carefully.
5. Hold the tabs on both sides of the staple cartridge and insert the cartridge into the original
position in the finisher.
Note: If you have trouble inserting the cartridge, ensure that the staples are positioned
correctly in the cartridge.
Note: The booklet maker uses two staple cartridges. Booklet stapling requires that both
staple cartridges contain staples.
6. Repeat the procedure for the other staple cartridge.
7. Close the finisher side cover.
316
Xerox
®
AltaLink
®
B81XX Series Multifunction Printer
User Guide
Troubleshooting
To Next Page
Loading...
Need help?
General
