Installing the Internal Hard Disk 75
IE
IE
Installation Procedure
The internal hard disk goes into the controller
board right above a font ROM or PostScript
®
ROM. If you purchased one of these ROMs, install
it before installing the internal hard disk. For
information on how to install a ROM to the printer,
refer to the installation guide provided for the
ROM.
Follow these steps when installing the internal
hard disk to the printer.
When uninstalling the internal hard disk, use the
reverse procedure described below.
1. Switch the power off by pressing the power
switch located on front lower right of the
printer to the <O> position.
Unplug the power cord from the power outlet
and the printer.
2. Remove the two screws that secure the rear
cover to the printer.
3. Pull the rear cover forward and remove it
from the printer.
4. Loosen the three screws that secure the
metal plate cover inside the printer.
5. Pull the metal plate cover forward and
remove it from the printer.
6. Insert the connector on the hard disk into the
connector on the printer (located at the right
of the controller board).
PostScript ROM or font ROM
Hard disk
Hard disk connector
To Next Page
Loading...
Need help?
General