Manual Mode
In MANUAL mode, you must manually start the fax
reception when you receive a fax call. In order to receive
the fax, you must press START. Automatic reception
is not possible with this setting. e Manual mode is
useful if you would like to receive faxes on a connected
computer.
Fax Mode
In the Fax mode, the machine will ring for as many
times as you have set with function 17. en the fax
reception switches on.
If you lift up the handset on an additional telephone that
is connected to the EXT outlet, and you hear that you
are receiving a fax call (whistling tone or silence), you can
start the fax reception process by pressing
*5
, or by
pressing START on the machine.
EXT/Answering machine
You should set the device to this mode if you have ad-
ditional devices connected to the EXT outlet of your
machine, especially an external answering machine. If
an additionally connected answering machine receives
a call, your machine will check to determine whether or
not the incoming call is a fax transmission. If the device
recognizes a fax signal, it will automatically receive the fax
transmission. If you do not have an answering machine
connected or if a connected answering machine does not
accept the call, the machine will take over the call after a
predetermined number of rings and automatically receive
any possible fax transmission being sent.
If you lift up the handset on an additional telephone that
is connected to the EXT outlet, and you hear that you
are receiving a fax call (whistling tone or silence), you can
start the fax reception process by pressing
*5
, or by
pressing START on the machine.
¡
To use this function, additional telephones
must be set to the tone dialing mode
(DTMF tones) (see the chapter entitled Installa-
tion / Easylink).
Reading machine counters
To get a count of pages printed:
Press MENU/OK,
661
and OK (printed PG).
To get a count of outgoing fax pages:
Press MENU/OK,
662
and OK (sent PG).
To get a count of incoming fax pages:
Press MENU/OK,
663
and OK (received PG).
To Next Page
Loading...
Need help?
General
