7. PC Connection
37
Chapter 7. PC Connection
English
Next you will be asked to accept the licensing conditions.
Click on Y.
e program can now commence with the installation.
Click on I.
At the conclusion of the installation process you must
restart your computer. Make your selection as to whether
the computer should restart automatically or whether
you would like to restart the computer yourself at a later
time. Click on F.
Only after the restart, connect the laser machine to
your PC with a typical USB cable. e USB port of your
device can be found on the rear side.
Uninstalling the Software
Close all open programs and applications before begin-
ning the uninstall process. Load the uninstall program by
clicking on S > P > C S >
C S > U in the Start menu. Your
computer will now prepare for the uninstall process.
You can either repair the program or remove it. Select
R and click on N.
You will be asked to conrm the uninstall. After you have
clicked on OK, the C S will be removed
from your computer. At the conclusion of the uninstall
process you must restart your computer. Make your selec-
tion as to whether the computer should restart automati-
To Next Page
Loading...
Need help?
General
