System Guide 1-13
Gateway and Network Configuration
NOTE: It is recommended to set this after the first connect attempt
has been made since the Preferred Server Name should be
automatically available under normal conditions.
NetWare gateway configuration
In Gateways using the NetWare tab, the administrator can
configure the NetWare Network automatically or manually. If the
automatic mode is selected, a “wizard” steps the administrator
through the configuration of the Novell Server and the NetWare
Printer queues for the Xerox FreeFlow Print Server.
If the manual mode is selected, the interface enables manual
entry and filtering for the Novell setups and printer queues.
LPD gateway configuration
In Gateways using the LPD (Line Printer Daemon) tab, the
administrator can enable or disable the LPD protocol, set the
default queue, and set the LPD port. The default port is 515, the
most commonly used port.
Network configuration settings
Within the System Administration part of the user interface,
Network configuration options are presented.
IP configuration
In Network Configuration, using the IP Address tab, the
administrator can enable or disable IP. If IP is enabled, the
administrator can adjust or change the following settings:
• IP Address
•Host name
• Subnet mask
• Default gateway
The administrator must also select the IP Configuration Method.
The drop down menu presents two options: a “Static” IP
configuration which allows the user to specify the IP values, or
“DHCP” method which allows a DHCP server to provide IP
information.
NOTE: The user is prompted whenever a reboot is required.
To Next Page
Loading...
Need help?
General
