Xerox Phaser 3100MFP/S User Manual

Phaser 3100MFP/S
- 23 -
3 - Copy
Scanned original setup
If you want, you can change the origin of the scanner.
By entering new values for X and Y in mm (X < 209 and
Y < 280), you move the scanned area as shown on the
diagram below.
 843 - ADVANCED FCT/COPY/ORIGIN
1 Press , enter 843 using the keypad.
2 Select the X and Y coordinates with the buttons 
or .
3 Setup the desired coordinates with the numerical
keypad or the buttons  and .
4 Confirm your choice by pressing the OK button.
5 Exit this menu by pressing the button.
Contrast setup
The CONTRAST parameter allows you to choose your
output’s contrast.
 844 - ADVANCED FCT/COPY/CONTRAST
1 Press , enter 844 using the keypad.
2 Setup the desired level of contrast with the buttons
 and .
3 Confirm your choice by pressing the OK button.
4 Exit this menu by pressing the button.
Brightness setup
The BRIGHTNESS parameter allows you to lighten or
darken your output.
 845 - ADVANCED FCT/COPY/BRIGHTNESS
1 Press , enter 845 using the keypad.
2 Setup the desired brightness with the buttons 
and .
3 Confirm your choice by pressing the OK button.
4 Exit this menu by pressing the button.
Paper type setup
 851 - ADVANCED FCT/SCAN. & PRINT/PAPER
TYPE
1 Press , enter 851 using the keypad.
2 Select NORMAL or THICK with the buttons 
and .
3 Confirm your choice by pressing the OK button.
4 Exit this menu by pressing the button.
Paper tray selection
The Automatic selection can have two meanings
depending on the paper size defined for the paper trays.
The following table describes the different cases.
 852 - ADVANCED FCT/SCAN. & PRINT/TRAY
PAPER
1 Press , enter 852 using the keypad.
2 Select the default paper tray to use, AUTOMATIC
or MANUAL, with the buttons  and .
3 Confirm by pressing the OK button.
4 Exit this menu by pressing the button.
Margin Shift using the Document Glass
If you want to, you can offset the lateral margins of the
document to the left or right during the scanning from the
document glass.
 854 - ADVANCED FCT/SCAN. & PRINT/
FLATBED MARG
1 Press , enter 854 using the keypad.
2 Setup the left / right margins offsets (by 0.5 mm
steps) with the buttons  and .
3 Confirm by pressing the OK button.
4 Exit this menu by pressing the button.
Left and right printing margin shift
If you want to, you can offset the lateral margins of the
document to the left or right during printing.
 855 - ADVANCED FCT/SCAN. & PRINT/
PRINTER MARG
1 Press , enter 855 using the keypad.
2 Setup the left / right margins offsets (by 0.5 mm
steps) with the buttons  and .
3 Confirm by pressing the OK button.
4 Exit this menu by pressing the button.
Default tray Tray used for copy
Same paper
size in the
trays
AUTOMATIC
Selection between the
main tray and the
manual tray.
Manual
The manual tray is
used.
Different
paper size in
the trays
AUTOMATIC The main tray is used.
Manual
The manual tray is
used.

Xerox Phaser 3100MFP/S Specifications

General

Brand	Xerox
Model	Phaser 3100MFP/S
Category	All in One Printer
Language	English