28. Remove the white plastic end cap. 29. On the opposite side of the hopper, release and remove
the small spring.
27. Remove the bottom metal plate.
Carefully pry it off the locking tabs located one on each side, and one in the middle of the hopper.
XEROX PHASER 3600 • TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS
© 2012 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only.
UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact techsupport@uninetimaging.com
www.uninetimaging.com
To Next Page
Loading...
