Printing on Specialty Media
Phaser® 6300/6350 Color Laser Printer
3-22
Printing on Specialty Media
This section includes:
■ Printing Transparencies on page 3-22
■ Printing Envelopes on page 3-27
■ Printing Labels on page 3-30
■ Printing Glossy Paper on page 3-34
■ Printing Custom Size Paper on page 3-39
Printing Transparencies
Transparencies can be printed from all trays. They should be printed on one side only. For best
results, use only recommended Xerox transparencies. See the Recommended Media List at
www.xerox.com/office/6300_6350support
.
To order paper, transparencies, or other specialty media, contact your local reseller or go to
www.xerox.com/office/supplies
.
Caution: Damage caused by using unsupported paper, transparencies, and other specialty
media is not covered by the Xerox warranty, service agreement, or Total Satisfaction
Guarantee. The Total Satisfaction Guarantee is available in the United States and Canada.
Coverage may vary outside these areas; please contact your local representative for details.
Transparency Guidelines
■ Remove all paper before loading transparencies in the tray.
■ Do not load more than 25 sheets in Tray 1 (MPT). Do not load more than 200 sheets in
Trays 2–5. Overloading the tray may cause the printer to jam.
■ Handle transparencies by the edges using both hands to avoid fingerprints and creases,
which may cause poor print quality.
■ Fan transparencies before loading in the paper tray.
To Next Page
Loading...
