Xerox Versant 2100 - Page 116

Recommended solutionPossible causeFault codeFault Area
Power Off / On the press.
If error persists, contact the
Customer Support Center.
General Fuser faults099-[00-99]xFuser
Fuser Belt Assembly is out of
position. Reseat the assembly
and make sure the Belt Edge
Sensor is in contact with the belt
edge.
Fuser Belt Out Limit Fail099-340
Power Off / On the press.
If error persists, contact the
Customer Support Center.
Press power faults060-3[00-99],
061-3[00-99],
061-6[00-99],
061-9[00-99]
ROS
Check accepted paper is loaded
correctly in trays, clear any pa-
per jams, and completely close
all trays, drawers and doors on
press.
Incorrect paper position-
ing, Entrance area paper
jam faults, Paper tray
faults, Paper path sensor
faults, Open drawer faults,
Open door interlock faults
071-1[00-99],
071-2[00-99],
072-1[00-99],
072-2[00-99],
073-1[00-99],
073-2[00-99],
075-1[00-99],
075-2[00-99],
075-3[00-99],
075-6[00-99],
076-1[00-99],
076-2[00-99],
076-3[00-99],
077-1[00-99],
077-2[00-99],
077-3[00-99],
077-4[00-99],
077-6[00-99],
077-9[00-99],
078-1[00-99],
078-2[00-99],
078-3[00-99],
078-4[00-99],
078-6[00-99],
078-9[00-99]
Paper Handling /
Transport
Power Off / On the press.
If error persists, contact the
Customer Support Center.
089-313, 089-
314, 089-316,
089-317
Registration
Create an Auto Alignment Pro-
file at the Stock Library Man-
ager. If error persists, contact
the Customer Support Center.
Registration error; press
detected less than optim-
al registration thresholds
26-401
Xerox
®
Versant
®
2100 Press10-14
User Guide
Problem Solving