Installation
Xerox® Smart Card
Installation Guide
14
To determine the network time, view the time as displayed on your computer. To observe or set the
time on the machine use the following instructions:
Note: If using Network Time Protocol (NTP) do not change the time on the device. The device will
obtain the time from the NTP server.
WorkCentre 5632/5638/5655/5665/5675/5687, Xerox WorkCentre 5135/5150 and Xerox
WorkCentre 5030/5050:
a. At the Xerox WorkCentre, press the Access button on the control panel.
b. Input your User Name and/or Password.
c. Select Go to Tools.
d. Select System Settings.
e. Select Time and Date.
f. Select Set Date and Time.
g. Select Set Time.
h. Observe the time and if it is not correct, validate that the GMT offset is correct for your
region.
Note: If any changes are made, the device will automatically reboot.
WorkCentre 5735/5740/5755/5765/5775/5790:
a. At the WorkCentre, press the Machine Status button on the control panel.
b. Select the Tools tab.
c. Enter the appropriate User ID and Password to access Tools.
Note: The default user name and password are: admin and 1111.
d. Select Device Settings.
e. Select General.
f. Select Date & Time.
• Date: Select the Format required and enter the Month, Day and Year.
• Time: Enter the correct Hour and Minutes and select PM or AM. If a 24 hour clock is
required, select the 24 hour clock option and enter the Hour and Minutes using the 24
hour clock format.
• GMT Offset (Time Zone) (System Software 06x.130.xxx.xxxxx): Use this option to set
the difference between your local time and Greenwich Mean Time. Enter the GMT Offset
time between -12.0 and 14.0 hours using the arrow buttons.
• Time Zone (System Software 06x.131.xxx.xxxxx): Touch the Time Zone drop down
menu and select the correct time zone for your device’s locale. The machine time is
automatically adjusted if daylight savings is in effect in your time zone.
g. Select Reboot to save and reboot the device.
To Next Page
Loading...
Need help?
General
