Xerox WorkCentre 7220 Information

WorkCentre 7220-7225 Information Assurance Disclosure Paper
Ver. 1.0, January 2013 Page 51 of 61
4.8. FIPS
4.8.1. FIPS 140-2 Compliance
You can enable the printer to check its current configuration to ensure that transmitted and stored data is encrypted
as specified in FIPS 140-2 (Level 1). Once FIPS 140 mode is enabled, you can allow the printer to use a protocol or
feature that uses an encryption algorithm that is not FIPS-compliant, but you must acknowledge this in the
validation process. If FIPS mode is enabled, when you enable a non-compliant protocol such as SNMPv3 or NetWare,
a message appears to remind you that the protocol uses an encryption algorithm that is not FIPS-compliant. NOTE:
If you enable FIPS 140-2 Mode it may not be able to communicate with other network devices that use protocols
that do not employ FIPS 140-2 validated algorithms.
When you enable FIPS 140 mode, the printer validates its current configuration by performing the following checks:
• Validates certificates for features where the printer is the server in the client-server relationship. An SSL
certificate for HTTPS is an example.
• Validates certificates for features where the printer is the client in the client-server relationship. CA
Certificates for LDAP, Xerox Extensible Interface Platform (EIP 2.0), and Smart eSolutions are examples.
• Validates certificates that are installed on the printer, but not used. Certificates for HTTPS, LDAP, or SNMPv3
are examples.
• Checks features and protocols for non-compliant encryption algorithms. For example, NetWare, SNMPv, and
SMB use encryption algorithms that are not FIPS-compliant.
• Validates Minimum Certificate Key Length configuration is FIPS compliant (must be 2048 bit).
• Performs CAC, PIV, and .NET card validation.
• Verifies Digital Signing and Encrypted e-mail is FIPS compliant.
• IPSec over IPV6 and IPv4 are FIPS compliant.
When validation is complete, information and links display in a table at the bottom of the FIPS 140-2 configuration
page of the webUI.
• Click the appropriate link to disable a non-compliant feature, or protocol.
• Click the appropriate link to replace any non-compliant certificates.
• Click the appropriate link to acknowledge that you allow the printer to use non-compliant features and
protocols.

Xerox WorkCentre 7220 Specifications

General

Functions	Print, Copy, Scan, Fax
Print Technology	Laser
Color Output	Color
Copy Resolution	Up to 600 x 600 dpi
Scan Resolution	Up to 600 x 600 dpi
Fax Speed	33.6 Kbps
Standard Paper Capacity	1, 090 sheets
Duplex Printing	Yes
Memory	2 GB
Hard Drive	160 GB
ADF Capacity	50 sheets
Type	All-in-One
Print Speed	20 ppm
Copy Speed	20 cpm
Connectivity	USB 2.0, Ethernet
Network Connectivity	Ethernet
Operating System Compatibility	Windows, Mac, Linux