lnstallation
lf
the copier is
moved from
a cold
place
to a
warm
place,
condensation
may form inside the copier. Operation
of the copier in this condition
will
cause
poor
copy
quality
and
malfunctions.
Leave the copier at.room
temperature for
at
least 2 hours
before use.
1.
Remove the
copier
from
the bag.
2. Remove
the thumbscrews, tape and the
label from
the bottom of the copier.
Note: The
thumbscrews are there to
prevent
pressure
on the fuser roll during shipment.
Failure
to remove the thumbscrew willcause
a
paper
jam
when operating the copier.
3. Remove
all the
pieces
of tape
from
the
copier
and then
place
the copier on a level
surface.
XC351 skip to step
5
4. Remove
the
paper
tray
from
the top of the
coprer.
5. Press
the button to
open the
front
cover.
Vigorously
shake
the toner cartridge
horizontally
four
or five times.
Remove
the toner cartridqe
cover.
b.
7.
To Next Page
Loading...
