Xerox XC351

Drum Cartridge
Replacement
18.
Unfold and open
the exit tray.
19. Reinstall the
toner cartridge. Push it in
until it locks
in
place.
Close the front
cover.
The
following
steps must be
performed
to
reset
the copier.
20.While holding
lhe Exposure
button, turn on
the
power
switch.
.
All
indicators,
except the Ready
indicator, will light.
21 . Release
and then
press
and hold the
exposure button
untiljust the three
exposure indicators
light
(approximately
4
seconds).
Note:
lf the
three exposure indicators
do not
light,
turn
the
power
switch
off and then
pedorm
steps
20 and 21
again.
The
center exposure indicator
will
stay
lit
(the
outside lights
will
go
out) and the Ready
indicator will
light. The
drum
cartridge
counter reset
is
complete and
the copier
is
now ready
for
operation.
#
28