XT-009 Gps tracker user manual
14
9.19 Motion Sensor
z Setup: Send SMS shake+password+space+1-10 to the tracker to set up this function
(1-10 means the level of intensity)
z Send SMS shake+password+space+1 is the least sensitivity . Have to shake the tracker
strongly to get the alert.
z Send SMS shake+password+space+10 is the most sensitivity . Have to shake the tracker
slightly to get the alert
z Cancel: Send SMS shake+password+space+0 to remove this function.
9.20 SD card
A mini SD card can be put in the tracker’s SD card slot. The GPRS data can be saved in the SD
card if GPRS is off. It will send data to the GPRS server again when it is on.
z Setup: Send SMS sdlog+password+space+1 to activate the sd card-saving function
z Cancel: Send SMS sdlog+password+space+0 to the tracker to deactivate this function
9.20.2 Setup: Send SMS readsd+password+space+1 to ask the tracker to send data in the SD
card to the GPRS server.
Cancel: Send SMS readsd+password+space+0 to ask the tracker to stop sending data in the SD
card to the server.
9.21 ACC status alert
ACC green wire connect to the car’s ACC wire ,when ACC is on ,the tracker will send “accstart
“ ,when ACC is off ,the tracker will send “accstop “
z Alarm format：lat: 22.566923 long: 114.051331 speed: 90.00 28/11/10 03:33 F:4.32V,0,
Signal:F ACCstart imei:359587011016261 05 41.5 460 01 2533 720B
z Alarm format：lat: 22.566923 long: 114.051331 speed: 90.00 28/11/10 03:33 F:4.32V,0,
Signal:F ACCstop imei:359587011016261 05 41.5 460 01 2533 720B
(Note: each time when the ACC status changed it’ll send alarm )
9.22. Remote oil & electricity cut-off function
This function is using for the car owner to send a SMS remotely to stop a moving vehicle. Please
note that in certain country you cannot cut car main power cable.
z Setup: Send SMS : powercar+password+space+11 it will reply “power car OK” cut off car
oil and electricity
.
z Cancel: Send SMS :powercar +password+space+00 it will reply “power car OK”
restart car
again.
To Next Page
Loading...
