Xiaomi roborock User Manual

Setting
Start cleaning
When the ashing ring-shaped indicator starts to glow constantly, it means that the
charging of the device is completely completed. Press the Power button, or use the mobile
application to turn on the cleaning of the room.
Attention:
- Do not turn on the wet cleaning function when there is no one at home;
- It is recommended to rinse the nozzle for wet cleaning every 30 minutes of its use to
ensure a high-quality and e󰀩cient cleaning.
Removing the wet cleaning module
After the vacuum cleaner has cleaned the
necessary room and returned to the docking
station, grip the handles on both sides with
special clips and pull the module toward you.
Attention:
- If the vacuum cleaner is being charged or
not being used, remove the module for wet
cleaning from the device.
- If you installed the docking station on a
wooden oor, we strongly recommend that
you use a waterproof mat to avoid damage to the oor as a result of water leakage.
On/O󰀨
Press the Power button, then the ring-shaped indicator will light up. The device is ready for
use. If the vacuum cleaner is in the process of cleaning, press and hold the Power button
to turn it o󰀨, after which the unit stops cleaning.
Attention: do not turn o󰀨 the vacuum cleaner during recharging.
Cleaning
Press the Power / Cleaning button to start cleaning the room.
During cleaning, press any button on the device to pause it.
Attention:
- If the device’s charge level is too low, the vacuum cleaner will not clean the room. First
charge the device.
- If there is a signicant decrease in charge during cleaning, the vacuum cleaner will
automatically return to the docking station for recharging. When the vacuum cleaner is
charged to the required level, the device will automatically continue cleaning the room.
- Before switching on the cleaning mode, please remove all excess cables from the oor
(including the dock cable) so that the vacuum cleaner does not get tangled in the cables
during cleaning, as this may result in power failure, damage to the devices and damage to
the cables.
- If the cleaning time is less than 10 minutes, by default the device cleans the room twice.
Charging
Automatic mode: after cleaning, the vacuum cleaner automatically returns to the docking
station for recharging.
Manual mode: when the device is paused, press the Charging button to return the device
to the docking station for recharging.
During charging, an annular indicator ashes around the device.
Caution: If the device does not automatically nd the dock, transfer the vacuum cleaner to
the docking station by yourself.
Cleaning method
After turning on the device, the vacuum cleaner scans the room map and separates
it to the zones. In each zone cleaning begins along the walls, after which the vacuum
cleaner forms its route in a certain zone «along the serpentine», consistently qualitatively
removing the entire room. After cleaning the room, the vacuum cleaner automatically
returns to the docking station for recharging.
Cleaned zone 1 Cleaned zone 2
Cleaning zone 4 Cleaning zone 3
(not cleaned yet) (in process)

Xiaomi roborock Specifications

General

Brand	Xiaomi
Model	roborock
Category	Vacuum Cleaner
Language	English