Maintenance
Attachment for wet cleaning
* recommended to rinsing after each use
1. Remove the attachment from the wet cleaning module.
2. Rinse the attachment in water and allow it to dry.
Attention:
- It is strongly recommended to rinse the attachment for wet cleaning, otherwise dirty
water from the module can get into the lter.
- If it is too dirty, this can aect the eciency of its sliding on the oor. Please rinse the
attachment , and then use it.
- For optimal cleaning results, it is recommended to change the attachment for wet
cleaning once every 6-12 months.
Filter components
* recommended to renew every 1-3 month
1. Remove two lter components (right and left) with your own hand;
2. Install new lter components, make sure they are securely xed;
Caution: It is recommended to change the lter components every 1-3 months, depending
on the level of water contamination and the frequency of use of the device.
Wheel
* recommended to clean monthly
1. Turn the vacuum cleaner to remove the wheel.
2. Clean the wheel of excess dirt and hair.
3. Install the wheel in the vacuum cleaner.
Caution: To clean the wheel, use clean water, dry it and install it in the device.
Wheel
Axe
Support
Sensors
Wipe the vacuum cleaner sensors using a soft, dry cloth, including:
1. Four drop sensors placed below.
2. Distance sensors from the walls placed on both sides.
3. Placed below the contact zones for recharging.
Drop sensors
Wheel
Contact areas for recharging
Side brushes
Sensors for determining the
distance to the walls
To Next Page
Loading...
Need help?
General
