Maintenance
Dust collector and lter
* recommended to clean it weekly
1. Open the main top panel of the vacuum
cleaner, hold down the latches and remove
the dust bag.
2. Open the dust bag in the place where the
arrow marks are located, discard the debris.
Cleaning the lter
* recommended to clean every
two weeks
1. Open the dust bag at the point, where the arrow marks appear.
2. Fill the dust bag with a small amount of water, close it and shake it. After this, pour out
dirty water, repeat the procedure again. Now your lter is clean.
Attention:
- Rinse the lter with clean water without adding any detergents.
- When rinsing the lter, do not use brushes or wash with hands. It’s enough just to rinse
the lter.
3. Remove the lter, shake it o to remove any excess moisture, allow it to dry out in a
well-ventilated, sunny location until it dries completely, after which the lter can again be
used.
Press the catch to remove the lter.
Attention:
- It is strongly recommended to dry the lter before using it (at least 24 hours to dry the
lter).
- We recommend that you use two lters in turn.
Side brush
* recommended to clean it monthly
1. Turn the vacuum cleaner to unscrew the screw.
2. Remove and clean the side brush.
3. Replace and tighten the screw.
Attention: for optimal cleaning results it is recommended to change the side brush every
3-6 months.
Battery
The device is equipped with a high-capacity lithium-ion battery. To save battery properties
when using the device every day, we recommend maintaining a sucient battery level.
Caution: If the device is not used for a long time, turn it o, and the battery should be
charged at least every three months to avoid loss of its properties and characteristics.
Shitou Robot Vacuum
Manufacturer: OOO Beijing Shitou Technology;
Model: S5X;
Address: Beijing city, Haiding District, Heiquan Road, 8, C Building, 6 Floor, 6016, 6017,
6018 Oces.
To Next Page
Loading...
Need help?
General
