EasyManuals Logo

Xilinx Alveo U200 User Manual

Xilinx Alveo U200
53 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
Alternavely, you can install the ve deployment plaorm installaon packages individually.
If this is the case, install them in the following order.
Satellite controller rmware
Card management rmware
Base paron rmware
Plaorm validaon
Shell paron rmware
4. Flash the base rmware to the Alveo card using the command displayed in the output of the
previous step. It has the following format.
$ sudo /opt/xilinx/xrt/bin/xbmgmt flash --update --shell <base_name> --card <card_bdf>
The following command, described in Appendix D: Obtaining xbmgmt Command Opons,
can be used for obtaining the base_name and card_bdf command opons.
$ sudo /opt/xilinx/xrt/bin/xbmgmt flash --scan
5. You will be asked to conrm the update, as follows. Type y and press the Enter key.
Status: shell needs updating
Current shell: <current_base_partition_name>
Shell to be flashed: <base_partition_to_be_flashed>
Are you sure you wish to proceed? [y/n]:
Flashing will take up to 10 minutes.
IMPORTANT! Do not enter Ctrl + c in the terminal while the rmware is ashing as this can cause the
card to become inoperable.
IMPORTANT! N'entrez pas Ctrl + c dans le terminal lorsque le micrologiciel clignote, car cela pourrait
rendre la carte inulisable.
WICHTIG! Geben Sie im Terminal nicht Strg + c ein, während die Firmware blinkt, da dies dazu führen
kann, dass die Karte nicht mehr funkoniert.
Successfully ashing a new card results in a message similar to the one shown below. If the
command returns Card Not Found, perform a cold reboot, and retry. Otherwise, see
Chapter 7: Troubleshoong.
Updating shell on card[0000:65:00.0]
Bitstream guard installed on flash @0x1002000
Persisted 542227 bytes of meta data to flash 0 @0x7f7b9c1
Extracting bitstream from MCS data:
...........................
Extracted 27367156 bytes from bitstream @0x1002000
Writing bitstream to flash 0:
...........................
Chapter 4: Installing the Deployment Software
UG1301 (v1.8) February 5, 2021 www.xilinx.com
Getting Started with Alveo Accelerator Cards 26
Send Feedback

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xilinx Alveo U200 and is the answer not in the manual?

Xilinx Alveo U200 Specifications

General IconGeneral
BrandXilinx
ModelAlveo U200
CategoryComputer Hardware
LanguageEnglish

Related product manuals