EasyManuals Logo

Xilinx Alveo U200 User Manual

Xilinx Alveo U200
53 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
Bitstream guard removed from flash
Successfully flashed Card[0000:65:00.0]
1 Card(s) flashed successfully.
Cold reboot machine to load the new image on card(s).
If the card is up-to-date, you will see a message similar to the following.
Status: shell is up-to-date
Card(s) up-to-date and do not need to be flashed.
6. Cold boot your machine to load the new base rmware image on the FPGA.
IMPORTANT! Be sure to fully power OFF the machine and then power it ON again. The image will
not boot from ash if the machine is only rebooted.
IMPORTANT! Assurez-vous d'éteindre complètement la machine, puis de la rallumer. L'image ash ne
démarrera pas si la machine n'est pas redémarrée.
WICHTIG! Schalten Sie das Gerät vollständig aus und wieder ein. Das Image startet nicht von Flash,
wenn der Computer nur neu gestartet wird.
7. Flash the Satellite Controller (SC) rmware to the Alveo card using the same command to
ash the base rmware. It has the following format:
$ sudo /opt/xilinx/xrt/bin/xbmgmt flash --update --shell <base_name> --card <card_bdf>
See Appendix D: Obtaining xbmgmt Command Opons for obtaining the command opons.
You will be asked to conrm the update, as follows Type y and press the Enter key.
Status: SC needs updating
Current SC: <current_sc_version>
SC to be flashed: <sc_version_to_be_flashed>
Are you sure you wish to proceed? [y/n]: y
Flashing will take up to 5 minutes.
Successfully ashing the SC results in a message similar to the one shown below. No reboot
is necessary.
Updating SC firmware on card[0000:65:00.0]
Stopping user function...
........................................
Successfully flashed Card[0000:65:00.0]
1 Card(s) flashed successfully.
If the card is up-to-date, you will see a message similar to the following.
Status: shell is up-to-date
Card(s) up-to-date and do not need to be flashed.
8. Program the shell paron using the following command.
$ sudo /opt/xilinx/xrt/bin/xbmgmt partition --program --name <shell_name> --card <card_bdf>
Chapter 4: Installing the Deployment Software
UG1301 (v1.8) February 5, 2021 www.xilinx.com
Getting Started with Alveo Accelerator Cards 27
Send Feedback

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xilinx Alveo U200 and is the answer not in the manual?

Xilinx Alveo U200 Specifications

General IconGeneral
BrandXilinx
ModelAlveo U200
CategoryComputer Hardware
LanguageEnglish

Related product manuals