Xilinx Alveo U200 User Manual

Use the following command, described in Appendix D: Obtaining xbmgmt Command Opons,
for obtaining the card_bdf and shell_name opons.
$ sudo /opt/xilinx/xrt/bin/xbmgmt partition --scan
Aer programming the shell, an output similar to the following example will be displayed.
Programming PLP on Card [0000:65:00.0]...
Partition file: /opt/xilinx/firmware/u250/gen3x16/xdma-shell/
partition.xsabin
Program successfully
Aer the shell paron is programmed, it is not necessary to reprogram it unless the system
is warm or cold rebooted.
IMPORTANT! Prior to running an applicaon on DFX-2RP plaorm, it is necessary to rst program
the shell paron on the card or the applicaon will fail to detect the shell and will not run. See Xilinx
Answer Record 71915 for details.
The installaon for deployment is now complete.
Related Information
Card Bring-Up and Validaon
Chapter 4: Installing the Deployment Software
UG1301 (v1.8) February 5, 2021 www.xilinx.com
Getting Started with Alveo Accelerator Cards 28
Send Feedback

Xilinx Alveo U200 Specifications

General

Brand	Xilinx
Model	Alveo U200
Category	Computer Hardware
Language	English