60
1. Hardware wiring
2. Recommended brake resistance specifications
min resistance (cannot be
less than this value)
External regeneration
resistance
External regeneration
resistance
(recommended power
value)
Note:
(1) The smaller the resistance is, the faster the discharge will be, but it is easy to break down the
resistance if it is too small. Therefore, the lower limit should be as close as possible but not less than
the lower limit when selecting the type.
(2) When wiring, please use high temperature resistant and flame-retardant wires, and pay attention that
the regenerative resistance surface does not contact with the wires.
To Next Page
Loading...
Need help?
General
