XO FLEX – Installation instructions Necessary tools
11
3 NECESSARY TOOLS
The following tools are necessary for installing, adjusting and servicing the XO FLEX unit:
3.1 STANDARD TOOLS
• Hammer drill for at least 18 mm concrete drill bit (SDS-system recommended)
• Carbide drill bit for concrete 18 mm (SDS-system)
• Carbide drill bit for concrete 10 mm (SDS-system)
• Wood bit 6 mm and 8 mm
• Spirit level 20 – 30 cm
• Combination wrench 17, 19 and 22 mm
• Socket spanner with extension 19 mm
• Torx screwdriver: T8, T9, T10, T15, T20, T25, T30 and T40
• Pozidrive screwdriver: PZ 1-2-3
• Allen key set: 1.5 – 10 mm
• Digital multimeter
3.2 SPECIAL TOOLS SUPPLIED WITH THE UNIT
• Special wrench (MG-416)
3.3 NECESSARY SPECIAL TOOLS AVAILABLE FROM XO CARE
• Manometer, four holes, Midwest – for adjustment and control of drive air pressure to air
instrument (turbine) (FA-041)
• Four carrying handles for the unit stand (AN-181)
• Flowmeter – for adjustment and control of cooling air for motor (FA-400)
• Antistatic wristband (UC-600)
• Drill template 1:1 (AP-919)
3.4 OTHER SPECIAL NECESSARY TOOLS
• Torque wrench 75 Nm
• Two component flame retardant foam: Würth part nr 0893 303 200
To Next Page
Loading...
