Xo FLEX - Operating Light Usage; Positioning the Operating Light

59 pages

To Next Page

To Previous Page

XO FLEX – Installation instructions Installation

Figure 49 – Securing the cables

Figure 50 – Fitting the upper part of the outer cylinder

Main Page

Table of Contents3
Introduction5
Installation Requirements6
Supplies and Connections6
Dimensions of Operatory8
Ceiling Height8
Operating and Transport Conditions8
Floor10
Fuse Replacement10
Necessary Tools11
Standard Tools11
Special Tools Supplied with the Unit11
Necessary Special Tools Available from XO CARE11
Other Special Necessary Tools11
Transportation and Unpacking12
Transport12
Unpacking12
Installation15
Installation Kit15
Installation of the Unit Stand15
Installation of the Unit in a Concrete Floor16
Installation of the Unit Stand in a Wooden Floor Structure16
Seal Opening in the Floor17
Positioning the Unit Stand17
Alignment of the Unit Base20
Alignment of the Supporting Leg22
Checking Clearance between Base and Floor23
Installation of the Unit on a Steel Plate23
Fitting the Bridge Arm and Instrument Bridge25
Over-The-Floor Installation28
X-Ray Adaptor28
Fitting of Operating Light29
Unpacking the Operating Light29
Fitting the Light Arm Post29
Fitting the Light Arm Cylindric Cover31
Ceiling Height Less than 255 CM31
Fitting the Light Arm32
Fitting the Brake33
Fitting the Cables to the Operating Light34
Fitting of XO HD Display34
Assistant Call39
Suction Hoses39
Installation of Dürr Intra Oral Camera40
Finalizing Installation of the Instrument Bridge40
Connecting Water, Compressed Air, Suction/Drain and Power Supply40
Connecting 230 V and the Suction Motor41
Connecting Mains Supply Cable41
Connecting Suction Motor Control Cable42
Fitting the Patient Chair42
Finalizing the Installation44
Attach the Patient Chair Seat Upholstery44
Fit the Cuspidor Bowl and Cup Holder44
Fit XO Water Disinfection and XO Suction Disinfection Cartridges44
Connection of External Equipment45
Checking the Unit46
Adjustment of the Instrument Balance Suspension46
Start and Check the Unit47
Finalizing the Installation48
Adjusting the Unit48
Adjusting the Air Instrument (Turbine), Drive Air and Cooling Air of the Micromotor48
Adjusting the Balance Spring and Friction Brake in the Bridge Forearm50
Adjusting the Pivoting Jonts of the Bridge Arm51
Adjustment of the Friction Brakes in the Operating Light Arm and Display Arm52
Adjusting the Cuspidor and Cup Filler53
Handing the Unit over to the Users55
Symbols56

Xo FLEX - Operating Light Usage; Positioning the Operating Light

Table of Contents

Other manuals for Xo FLEX

Related product manuals