XO CARE A/S
YB-223 Version 3.00 XO Osseo, User Guide 17
Fig. 15
1. Enter the adjustment mode by clicking once into the central adjustment port with the adjustment
pin. The cursor now indicates that the torque is open for setting.
2. Adjust as desired. Increase by clicking the (+) port to the right and decrease by clicking the (-)
port to the left.
3. Open the irrigation flow rate (H2O) for setting by clicking once again into the central adjustment
port and adjust as in point 2 above.
4. Store your settings either by clicking the central port until the cursor vanishes or by stepping
once on the motor ON/OFF switch on the foot control.
You are now ready to operate with your own parameter settings. Start the handmotor by stepping
and holding the motor ON/OFF switch on the foot control.
F. CLEANING AND STERILIZATION
F.1 CONTROL BOX AND FOOT CONTROL
Clean and disinfect the control box, bag hanger and foot control by wiping all surfaces thoroughly
with an alcohol sponge or a micro-biologically tested surface disinfectant.
The control box and foot control cannot be autoclaved.
F.2 IRRIGATION TUBING
The irrigation tubing kit is for one time use only. Discard after use. Cannot be re-sterilized.
F.3 HANDPIECE
To Next Page
Loading...
Need help?
General