Need help?Do you have a question about the XTA DS800 and is the answer not in the manual?
Two transformer balanced outputs for broadcast/recording feeds.
Selects channel gain from +10dB to +50dB.
Selects input impedance and padding for mic or line level signals.
Provides switchable 48V phantom power for condenser mics.
5-segment LED meter shows signal level below clipping.
Routes selected channel to headphone/solo bus for monitoring.
Auto 10dB pad when 48V phantom power detected.
Controls headphone output volume.
Standard socket for headphone connection.
LED indicates the unit is powered on.
Monitor output connected to the monitor desk.
Front of House output connected to the FOH desk.
Multifunction input for microphones and line level signals.
Output for multi-unit applications, connecting to Solo Bus In.
Input for multi-unit applications, connecting to Solo Bus Out.
Combined IEC inlet, fuse, and power switch.
Standard setup links inputs to corresponding 4 outputs.
Jumper links allow changing input/output configurations.
Example setup: 4 inputs driving 8 outputs each.
Example setup: 1 input driving 16 outputs.
Details on impedance and CMRR for microphone and line inputs.
Specifications for FOH, MON, and Isolated transformer balanced outputs.
Available gain settings via a 5-position switch.
5-point LED indicator for signal level relative to clipping.
±0.5dB from 20Hz to 20kHz.
Noise performance at different gain settings.
Total Harmonic Distortion (THD) specification.
Types and pinouts for input and output XLR connectors.
Operating voltage and frequency range.
Maximum power draw of the unit.
Net and shipping weight.
Physical dimensions (Height, Width, Depth).
Available optional transformers.
To Next Page
General
