Page 9 DS8000 Operator’s Manual
Installing your DS8000:
Installing your DS8000:Installing your DS8000:
Installing your DS8000:
Unpacking
After unpacking the unit, please check it carefully for any damage. If any is found,
immediately notify the carrier concerned - you, the consignee, must instigate any claim.
Please retain all packaging in case of future re-shipment.
The Design House
Vale Busin ess Pa rk
Worcester R oad
Worcs.
England
Tel +44 (0) 12 99 8 79977
Fax +44(0) 12 99 879996 9
Electrical Considerations
The unit is fitted with a universal power supply that will operate from 100V to 240V AC mains.
Make sure power outlets conform to the power requirements listed on the back of the unit.
Damage caused by connecting to improper AC voltage is not covered by the warranty.
Mechanical Considerations
To ensure that this equipment performs to specification, it should be mounted in a suitable
rack or enclosure. As this unit is convection cooled, ensure that there is adequate clearance
around the vents on the sides of the unit to allow air to circulate.
Make sure that the rack unit has a separate earth connection (technical earth).
Please also see the notes regarding maintenance on page 23.
To Next Page
Loading...
Need help?
General
