14
MONITOR OPERATION
GETTING FAMILIAR WITH THE CONTROL PANEL
Key Functions
FUNCTIONAL BUTTON:
MODE – Push down to select functions.
SET - To Set the consumer movement of time, distance, calories and hand pulse.
RESET -For resetting consumer movement of time, distance, calories and hand pulse.
FUNCTIONS AND OPERATIONS
1. SCAN: Press the MODE button until SCAN appears, the monitor will rotate through the 6 functions: time,
speed, distance, calorie, odometer, and pulse. Each display will be held 6 seconds.
2. TIME: Shows your elapsed workout time. Press the MODE button until “TIME” appears, press SET button to
set target time. If you continue to exercise once your target time is reached the computer will reset
itself and start counting up from 0.
3. SPEED: Display current speed.
4. DISTANCE: Count the distance from exercise start to end. The maximum value is 999.99miles. Press the MODE
button until “DISTANCE” appears, press SET button to set target distance. If you continue to exercise
once your target distance is reached the computer will reset itself and start counting up from 0.
5. CALORIE: Count the total calories from exercise start to end. Press the MODE button until “CALORIE” appears, press
SET button to set target calories. If you continue to exercise once your target calorie is reached the
computer will reset itself and start counting up from 0.
6. ODOMETER：Monitor will display the total accumulated distance.
7. PULSE RATE: Press the MODE button until “PULSE” appears. Press SET button to set target heart rate. The heart rate
range can be set anywhere from 40 - 240 BPM. If you continue to exercise once your target heart
rate is reached the computer will reset itself and start counting up from 0.
Before measuring your pulse rate, please place your palms of the hands on both of the contact pads. The monitor will
show your current heart rate in beats per minute(BPM) on the LCD after 6~7 seconds.
During the process of pulse measurement, the measurement value may be higher than the actual pulse rate during
the first 2~3 seconds of reading, after which it will stabilize and display a more accurate reading. The heart rate
measurement value is not intended to be and should not be used as the basis for medical treatment.
NOTE：
1. If the display is faint or shows no figures, please replace the batteries.
2. The monitor will automatically shut off if there is no signal received after 4 minutes.
SPECIFICATIONS:
To Next Page
Loading...
Need help?
General
