2. Reset must be performed in the following cases:
The brake pad and brake pad wear sensor are replaced.
The brake pad indicator lamp is on.
The brake pad sensor circuit is short, which is recovered.
The servo motor is replaced.
The operation guidelines of the EPB function are shown below:
1. Enter the EPB menu and choose relevant models according to the
vehicle being tested.
2. Follow the instructions displayed and press YES after completing the
instructions shown.
Figure 5-4 Sample of EPB function (screen 1)
3. Enter the Enter maintenance mode menu and release the
handbrake brake. And press OK after completing the instructions
shown.
To Next Page
Loading...
Need help?
General
