Xtool VAG401 - 3.3 Erase fault codes; 3.4 Read measuring data value

21 pages

To Next Page

To Previous Page

VAG401 VW/AUDI/SEAT/SKODA

www.Xtooltech.com 11

3.3 Erase fault codes

Select

[05-Clear Codes] and then press [Enter] as the following.

You need to press [Enter] button for the second time to perform “code

erase”. Of course you can also press [Esc] button to give u. If code erasing

successfully, it will display as the following.

3.4 Read measuring data value

Select

[08-Measure Blocks] and then press Enter as the following.