VESDA Commissioning Guide VESDA by Xtralis
10 www.xtralis.com
For Xtralis VSC: Select Devices Menu/Tree - Detector Form Reference Tab
1. Give a reference address number or enter 255 if there is no reference detector.
2. Set the dilution factor
3. Set the delay time
AutoLearn
For LCD Programmer: See LCD screen 20, 59, 90
l Enter the length of time you want to run AutoLearn
For Xtralis VSC: Select Devices Menu/Tree - Detector Form - Autolearn Tab
l Enter the length of time you want to run AutoLearn
Filter
For LCD Programmer: See LCD screen 27, 66, 96
l Enter the filter service interval
For Xtralis VSC: Select Devices Menu/Tree - Detector Form
l Enter the filter service interval
Communications
For LCD Programmer: See LCD screens 39, 78, 104, 121, 130, 137, 155.
l Set the network delay
l Set the preferred port
l Set the health check
l Set the open-ended Loop (not available in System/All Device - Screen 155)
l Set the network delay
l Set the preferred communications port.
For Xtralis VSC: Select VESDAnet Form - Communications Tab
l Set network delay
l Set the Health Check period
l Set the preferred communications port. Select the end of chain port if the detector is at the end of an
Open-ended Loop.
General Purpose Input
For LCD Programmer: See LCD screens 40, 79, 105. Select the required GPI function from:
l Mains OK
l Standby Mode
l Remote Isolate (not available for VESDA VLC)
l Use Night-time Threshold (not available for VESDA VLC)
l Reset/Isolate Function
l Inverted Reset Function (not available for VESDA VLC)
l Reset (not available for VESDA VLC)
For Xtralis VSC: Select Devices Menu/Tree and GPI Inputs Tab to set:
l Mains OK
l Standby Mode
l Remote Isolate (not available for VESDA VLC)
l Use Night-time Threshold (not available for VESDA VLC)
l Reset/Isolate Function
l Inverted Reset Function (not available for VESDA VLC)
l Reset (not available for VESDA VLC)
UL Version
For LCD Programmer: See LCD screens 40, 79, 105, 131, 157. The UL Version may be selected or de-
selected from the Miscellaneous Screen.