49
10 Programming
10.1 Display – Control panel of the MASTER / SINGLE Inverter
10.2 Function of the push buttons
▲ Start of the HYDROVAR in the 1st Window
▼ Stop of the HYDROVAR in the 1st Window
◄ and ► Reset: by pressing of both buttons simultaneously for 5 seconds
▲
Increase of a value / selection of the submenu
▼ Decrease of a value / selection of the submenu
▲ + short ▼ Change to faster scrolling up of a value
▼ + short ▲ Change to faster scrolling down of a value
► Short pressing: enter submenu / Change to next parameter in the menu
◄ Short pressing: leave submenu / Change to previous parameter in the menu
►
Long Pressing: Acknowledgement of a determined action
◄ Long Pressing: Change back to the main menu
Read and follow the operating instructions carefully before you start
programming to prevent incorrect settings which will cause malfunction!
All modifications must be done by qualified technicians!
Power
Run
Error
To Next Page
Loading...
Need help?
General
